NF1-116 Nautic 6.5 Inch Speakers

MB Quart waterproof Nautic 6.5 Inch marine speakers (white) for boat and installations.

$ 69.99

In stock

Add to wishlist
SKU: 806576229636 Categories: , ,

The award winning MB Quart Nautic waterproof marine certified, 6.5 inch coaxial speaker for boat, RV and off-road vehicle audio installations. These speakers feature water resistant midrange cones, crystal clear tweeters and rust resistant connectors. Sold in pairs with grills in white.

Weight 3.25 lbs
Type

Speaker

Brand

MB Quart

Series

Nautic

Category

Marine, Powersports, RV

Condition

New

Color

White

Warranty

1 Year

IPX Rating

IPX67

CEA Standards

CEA426B

Speaker RMS Power Handling (watts)

40

Speaker Peak Power Handling (watts)

80

Speaker Impedance (ohms)

4 Ohm

Speaker Sensitivity

89dB

Speaker Mounting Diameter / Cut Out (in)

5

Speaker Outside Diameter (in)

7

Speaker Mounting Depth / Chassis Depth (in)

2.29

Speaker Size (in)

6.5

Proposition 65 Notice ​WARNING: This product can expose you to chemicals including LEAD, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Tweeters

.75 Inch Composite Dome: Very smooth musical response, high output with minimal required amplifier power.

Cone Material

6.5 inch Composite Poly Midrange: Water resistant composite polypropylene cone with temperature stable UV Butyl rubber surround mounted on a lightweight composite frame.

Surround / Cone Coupling

UV Butyl: Butyl Rubber remains musical in all weather. Does not stiffen in cold.

​Voice Coil / Former Assembly

High Temperature Voice Coil and Former: Voice coil is high temperature copper, wound on an aluminum former which allows the voice coil to handle more power while remaining light in weight.

Spider

Woven fiber composite spider to stabilize the cone and voice coil in all musical situations.

Cooling System

Front and rear venting allows air passage through the spider and back plate to exchange air over the voice coil.

Crossover

6dB high-pass: Clean and simple crossover design allows the most possible signal to get to the speaker from your source unit or amp.

Tweeter Hardware

Mounting hardware are Die Cast for strength and powder coated to resisted outdoor elements of sun, spray and dust.

Frame

Poly Composite Frame: Composites add strength to the frame without adding distortions or harmonics that can affect the tonal quality of the speaker and are weather resistant!

Motor

High Energy Motor assembly: High energy iron ferrite magnet for higher output and smaller overall size.

Grills

Composite Integrated: UV treated against sun fade and waterproof and are integrated into speaker frame for simple installation.

Hardware

Stainless Steel Screws

View/Download (1.1 MB)

MB Quart Nautic Speakers (NF1) Quick Start Guide (Rev1)