MB Quart Polaris Off-Road Grade Audio

ZA2 Amplifier

Audiophile in the Car

The engineers here at MB Quart designed the ZA2 line of amplifiers for one reason. "To deliver the best sounding amplifier available for a critical listening audio system."

 

But, they did not stop there, because we use the gear in our cars too, we also want to feel that beat, right?

 

With a mix of sound quality technologies, MB Quart amplifiers are about making music, not just sound pressure levels. The ZA2 amplifiers feature the unique Q-Stasis pre-amplifier circuitry to keep incoming noise from source units at nearly immeasurable levels and Class SQ designs with FLUID-FET output devices to mimic the sound quality of the highest end home and recording studio amplifiers. There is no doubt that these amplifiers have the high end sound and deep seated power to exceed your expectations.

 

The ZA2 line is available in 2 and 4 channel full range versions, plus a unique 5 channel that delivers a 5th channel that is 1 ohm stable and lastly a dedicated subwoofer amplifier that delivers 1000 watts at 1 ohm. Here is a quick view of some of that is happening in the ZA2 amplifier

 

On Board Equalization
The ZA2 Series of amplifiers have built in equalization to fine tune the system with Low Pass, High Pass and Level Control. Take a close look at the 5 channel controls and check out how much equalization control you have over frequency and gain to all five channels. It is a pretty amazing amplifier.

 

Class SQ
Multi-channel ZA2 amplifiers utilize the unique MB Quart Class SQ topology. Matched with Q-Stasis the sonic accuracy and clarity exceeds standard Class A/B amplifiers.

 
Q-Stasis
The highly engineered Q-Stasis pre-amplifier stage reduces incoming noise from source units dramatically improving sound quality.
 
Class Q1 Mono
MB Quart’s Class Q1 offers the efficiency of today’s D-Class with increased engineering to focus on sound quality from the power supply through the output devices, the FLUID-FETS.
 
FLUID-FETS
MB Quart output devices, FLUID-FETS are painstakingly selected for their ability to efficiently produce power and mimic the sound quality of the highest end home amplifiers.
 

All MB Quart ZA2 amplifiers feature:

  • High-end mobile audio amplifiers with striking design
  • Q-Stasis Pre-Amplifier Input Section
  • Class SQ Technology in 2, 4 and 5 channel amplifiers
  • Class Q1 Technology in Mono and 5th channel amplifier
  • FLUID-FET hand selected insulated MOSFET output devices
  • Focused mass heat sink designs
  • Bass Remote Included on mono and 5 channel amplifiers

ZA2-1600.4 Amplifier

« Previous Next »
ZA2-1600.4

More Views

http://mbquart.com/za2-1600-4/

Be the first to review this product

Availability: Discontinued

Part#: ZA2-1600.4

Details:

1600 watt, four channel car audio amplifier

Regular Price: $299.99

Special Price: $169.00

Overview

Part #: ZA2-1600.4 | SKU: 806576227052 | Category: MaxxFactory Products
Description
ZA2 1600 watt RMS, full range, bridgeable, Class SQ (Class A/B) Circuitry car audio amplifier with onboard electronic crossover

Specifications

Part #: ZA2-1600.4 | SKU: 806576227052 | Category: MaxxFactory Products
  • Class
    Class SQ (Class A/B)
  • Variable Voltage
    6.0V - 0.2V
  • Signal to Noise
    >90dB
  • Frequency Response
    10Hz-45KHz
  • Crossover Type
    Variable Electronic
  • High Pass Crossover:
    12dB Per Octave:

    60Hz-1.2KHz
  • Low Pass Crossover:
    12dB Per Octave:

    30Hz-250Hz
  • Crossover Frequency Range:
    CH1 & CH2:

    LPF 60-1.2KHz
    HPF 30-250Hz
  • Crossover Frequency Range:
    CH3 & CH4:

    LPF 60-1.2KHz
    HPF 30-250Hz
  • THD Percent
    <0.05
  • Bass Boost
    0-9db
  • RMS Power Output @ 1 Ohm:
    N/A
  • RMS Power Output @ 2 Ohms:
    4x400W
  • RMS Power Output @ 4 Ohms
    4x200W
  • RMS Power Mono Bridged @ 4 Ohms
    2x800W
  • Total Channels
    4
  • Audio Inputs:
    1 Pair RCA Jacks
  • Audio Outputs:
    1 Pair RCA Jacks
  • Power Terminal:
    12v/GND

    4 ga
  • Speaker Terminal Wire Gauge
    12 ga
  • Fusing
    25Ax2
  • Dimensions
    16.63 X 10.63 X 3.25 in
    41.4 x 26.6 x 8.2 cm
  • Weight
    8.2 lbs (3.7 kg)

Specifications

Part #: ZA2-1600.4 | SKU: 806576227052 | Category: MaxxFactory Products
  • Pre-Amp Circuitry: Q-Stasis Pre Amplifier Stage
    Maximum low voltage signal from the source unit comes into the amplifier circuit with minimal distortion
  • Inputs: Nickel Plated
    High temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant
  • Operation Mode: Four channel and bridged mono operation
    Flexible installation allows this amplifier to run in four channel or bridged mono mode.
  • Crossover / Signal Shaping: Adjustable High and Low Pass Filters
    With adjustable potentiometers the frequency division between high frequency speakers and low frequency drivers can be fine tuned for a perfectly balance audio system for all passengers, regardless of the placement in the vehicle
  • Class / Topology: Class SQ (Class A/B)
    Designed specifically by MB Quart engineers to deliver high sound quality with minimal distortion while developing plenty of power to the FLUID-FET devices
  • Output Devices Technology: FLUID-FETS
    Uniquely selected MOSFET devices, designed specifically to augment the Class SQ and Class Q1 circuitry of all MB Quart amplifier designs.
  • Heat Sink: Focused mass aluminum
    Unique low profile heavy duty aluminum heat-sink to dissipate heat
  • Power Supply: High frequency power supply design
    Maximum efficiency power supply to deliver maximum power with minimal impact on the vehicles electrical system
  • Output Connections: Nickel-Plated
    Nickel Plated Brass Connection with Hex Set Screw terminals allow for secure connection and resist erosion
  • Connections Type: Molded / Angled
    Secure connection for all system wires. Angled for ease of access for installation
  • Signal Pass Through: RCA outputs
    Daisy chain multiple amplifier to eliminate additional signal cables from the source unit
  • Diagnostics: Three-stage protection circuits
    Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel
  • Illumination: YES
    The MB Quart - Red Chiclet in the logo lights up to easily identify your amplifier as a top of the line, advanced technology choice

Technology

Part #: ZA2-1600.4 | SKU: 806576227052 | Category: MaxxFactory Products
More info in development & coming soon!

Specifications

Part #: ZA2-1600.4 | SKU: 806576227052 | Category: MaxxFactory Products
Files & Manuals


Write Your Own Review

Only registered users can write reviews. Please, log in or register

Maxxsonics Factory Specials
Maxxsonics Factory Specials